Electrical DIY
This module is designed to make interfacing with the 6rStager/10rstager much simpler.
Transbrake Button Bump Box Button Boost Scramble Button Nitrous Purge Staging Button Delay Button Line Lock Other 10 amp Momentary Red Pushbutton Switch custom made for Motion Raceworks. This unit is an Aerospace grade quality switch MADE IN THE USA!...
Tired of not having easy access to your trans brake switch? Tired of that easy access making driving the car miserable because you are fighting the wires wrapping around the steering column? This kit allows the addition of two extra...
This tool by Lisle has three sizes of slotted tubes for working on different sizes of Deutsch terminals (12GA,16GA,20GA) and works well with our bulkhead connectors. Slotted tubes are made out of stainless steel which work and last longer than...
Select a straight or 90 degree boot to seal the front and/or back of your connector. Shell size s24 Material: heat shrink material, Fluid-resistant elastomer INSTRUCTIONS: Position the heat-shrinkable boot/transition over the object to be covered (connector). Heat evenly until the until the...
5 pack of Polyimide (Kapton) Tape Includes one of each of the following widths; 1/8” 3/16” 1/4” 1/2” 3/4 (36 yards long each roll) Used to provide protection to wires from hi temps while shrinking boots etc. Use to temporarily bundle...
Black nylon plastic cable tie mounting eyelet Use with zip ties up to .2" / 5mm wide Available with or without stainless fasteners
THE SINGLE 4 GA WIRE CONNECTOR BULKHEAD COMES WITH 1 DEUTSCH DTHD SERIES CONNECTOR (BOTH SIDES OF THE CONNECTOR, PLUG AND RECEPTACLE) + THE CONTACT TERMINALS (PIN AND SOCKET). THIS IS A GREAT WAY TO PASS A 4 GA WIRE...
Isolated power and ground studs / junction studs used for connecting multiple power or ground wires at a single point for distribution. Power studs come with stainless hardware Material: Glass Filled Nylon Stud Sizes: 1/4, 5/16, 3/8 Melting Temp: 515º F (268ºC) Max...
Open barrel splice for inline and parallel splicing of wire. See video and selection chart (in the product photos) for details on how to properly splice. Splitting one wire into multiple wires can be done in many ways, this video...
Select a straight or 90 degree boot to seal the front and/or back of your connector. Shell size s24 Material: Plastisol, flexible 'rubber like plastic' - NOT heat shrink material, can easily be pulled back from connector for servicing connector
These terminals are used with our bulkhead connectors (Deutsch HD30 series) and DT series connectors (DTM/DT/DTP) The kits you purchase from our site come with standard pins and sockets, these are for spare/extra and the special green and purple banded...